FUTEK IPM52x (D520) Digital Display User Manual

Page 10

4. EX K

•

UT,

Y or SPEC), it exits to you back to RUN mode.

ER key should be pushed first to store

ENTER K

• Ent

tedly pushing

•

it st

SECTION 3.3: RUN MODE KEY FUNCTIONS

• When entering numeric data, it decrements the

numeric value of the flashing digit by one with eac
push.

IT EY

If at a Main branch prompt (CODE, CHAN, OUTP
DISPL

• If in a programming branch, it returns you to Main

branch prompt.

NOTE: It does note store data to memory on its
return. ENT
selected entry, then EXIT key.

EY ( on flow chart indicates to use this key)

ers selected Main program branc

> Moves you down in the program branch menu.
> Menu steps can be skipped by repea

ENTER key till desired menu step is reached.

Enters selected choices, numeric data or decimal point

ore the value and advances to next step in the

program menu.

. Entering SETUP

ill

y “SET CH” then display “CODE” or flash

rogram branch

this

red or if no code

Push and hold SETUP key for 4 seconds. Meter w
first displa
“SETUP then display “CHAN”.

• “CODE” is flashed with 00 if a lockout code ha

been set under the Main p
heading SPEC, CODE menu.
> The preset lockout must be entered at

time. If wrong code is ente
is entered within 20 seconds, meter will
return to RUN mode.
Upon correct lockout code entry, meter
enters the SETUP mod