FUTEK IPM52x (D520) Digital Display - Manual (Page 21)

20
4. "dSP Hi" (display high).
Either select "yES" or "nO"
If "yES" is selected, this allows you to apply
corresponding high input signal to input and
enter in corresponding high display value. Push
ENTER key to make displayed value equal
input. If “NO” is selected it skips over this
program and leaves values to what they were.
5. "EnAbLE" (Enable). This enables the above
calibration setup by the inputs. This allows for
the low value and high values to be set at
different times and then enabled when both are
complete.
• "NO" leaves calibration unchanged
• "YES" enables this calibration and
overrides any previous calibration by the
USER or SHUNT type calibration
2. Channel 5 (Math Channel)
a. "TyPE" Select for channel 3 to be one of following:
• "CHAn 1" channel 1’s raw input count
• "CHAn 2" channel 2’s raw input count
• “CHAn 3” channel 3’s raw input count
• “CHAn 4” channel 4’s raw input count
• "Add" Sum of Channel 1 and 2
• "Sub" Difference of channel 1 – 2
• “Div” Result of channel 1 ÷ 2
• “P1-P2” Peak1 – Peak2
• “AVG”
AVG of Channel(1+2+3+4)/4
• “SUM” Sum of all 4 channels
• “MUL” Product of CH1 x CH2
b. Raw input is displayed. For exact calibration purposes
you can input the low and high inputs and record their
value for entry in the low and high input values below.
NOTE: The low and high values are the result of the