FUTEK IPM52x (D520) Digital Display - Manual (Page 24)

23
alarm will remain on till manually reset. Use SELECT
key to view “YES” for latching and “NO” for non-
latching. Use the ENTER key to enter choice. Note:
“reset” function programmable for front panel key or
remote input, is used to reset the latched alarm.
h. "SAFE" ("ALARM 1" ONLY) selects alarms 1 through
3 to be in a safe mode(de-energizes on alarm) or
standard (energizes on alarm). Use SELECT key to
view “YES” for safe and “NO” for standard. Use the
ENTER key to enter choice. Note: This is used to
determine what the alarms do when loss of power
occurs to meter. With "SAFE" selected alarm will turn
on when power fails.
i. "FLASH" selects alarm to flash display when in alarm.
Use SELECT key to view “YES” for flash display and
“NO” don’t flash display. Use the ENTER key to enter
choice.
2. ANALOG OUTPUT
This setup menu programs the analog
output/retransmission.
a. "SOUrCE" selects what the analog output will be
based upon. Use SELECT key to view choices. Use
ENTER key to enter choice. After choice is entered
then addition choices are entered.
1. Selections are:
• "CHAn 1" Channel 1
a) "Gross" gross value
b) "nET" net value
c) "PEAK 1" peak 1 value
• "CHAn 2" Channel 2
a) "Gross" gross value
b) "nET" net value
c) "PEAK 1" peak 1 value
• "CHAn 3" Channel 3
a) "Gross" gross value