FUTEK IPM52x (D520) Digital Display - Manual (Page 27)

26
C. "nEt" assigns F key to switch displayed channel
between gross and net
• Pushing F key will switch displayed channel to
display net.
• Front panel NET LED will light to indicate
NET is being displayed.
• Push F key while net is selected will change
display back to gross.
• If different channel is selected while net is
selected, it will also display net.
D. "PEAk 1" and "PEAk 2" assigns programmed peak
function to F key
• Pushing F key will display the assigned peak
function. If peak was assigned peak LED on
front panel will also light. If Valley then valley
LED will light.
• Pushing F key for 4 seconds will reset the
peak/valley.
E. "ALAr 1" thru "ALAr 4" assigns alarm function to F
keys
• Pushing F key displays current alarm set point
• Pushing F key for 4 seconds allows set point
value to be changed.
Current set point is displayed with the right
most digit flashing. The set point can now
be changed with the UP and DOWN keys.
Select digit to be changed with SELECT
key. Press ENTER key to enter new value
into memory and return to RUN mode
F. "tArE 1", "tAreE 2", "tArE 3", "tArE 4” assigns F key
for tare function. 1 for channel 1, 2 is for channel 2, 3 is
for channel 3, 4 is for channel 4.
• Pushing F key will zero the channel for the
input present.