Thermo Fisher Scientific EcoScan DO 6 - Manual (Page 18)

Instruction Manual DO 6
10
3.6 Switching the Meter On
When switching the meter on, it will go
through a series of display, eventually
showing the revision number of the meter
before going to the measurement mode.
The mode of measurement which the
meter displays will be similar to the last
measurement mode to which the meter is
switched off.
Press ON/OFF key to power up your
meter.
1) All LCD segments will light up for 1.5
seconds.
2) The display will then momentarily
show the meter’s identification “DO 6”
with the annunciators for percentage
saturation mode and concentration
mode.
3) The display continues to switch to
display meter’s revision number for
1.5 seconds before finally showing
the measurement mode.
4) Either percentage saturation
measurement mode, concentration
measurement mode or temperature
measurement mode will be displayed
following the previous measurement
mode to which the meter is switched
off.
CAL 13 CAL 24
mg/l
NTU
ppm
%pH
TAvg
mg/l
ppm
%
ON
OFF
A
%
Figure 6: Power Up sequence