Thermo Fisher Scientific EcoScan DO 6 - Manual (Page 17)

Instruction Manual DO 6
9
3.5 Connecting the Probe to Meter
1) Insert the BNC connector from the electrode to the BNC connector socket
on the meter accordingly and rotate connector clockwise until it locks. See
Figure below.
2) To remove, simply rotate the connector in counter-clockwise direction until
it unlocks, and slide the connector off the socket.
3) Plug the phono jack of temperature sensor into the phono socket of the
meter as shown in Figure below.
Caution: Do not pull or force the probe cord or the probe wires might
disconnect.
Note: Keep connectors clean. Do not touch connector with soiled hands.
BNC Connector for
DO probe Phono jack for
Temperature probe
Figure 5: DO 6 probe to meter connections