KYORITSU 5020 Instruction Manual - Manual (Page 39)

̶ 36 ̶
additional recordings (up to 3 Memory Blocks),
it is recommended to set each Location No.
in advance. It is useful to identify the recorded
locations per Memory Block.
● Location No. is linked to the Location list and
allows to display the Location name, which
corresponding to the Location No., when
displaying data on PC Software.
● In case of setting Location no. on the
instrument, it is recommended to take notes of
the Location No. and the name.
5. "Auto-power-off":
State of Auto-power-off function is displayed.
On : Enables Auto-power-off function.
OFF : Disables Auto-power-off function.
◆ Press the button and proceed to the
next step (Time) when not changing the setting.
◆ To change the setting, press the button.
Then the indication on the LCD flashes. Press
the
or button to set the value to
the desired one. Then press the button
to confirm it.
Point
" " mark appears on the LCD when this
Function is "OFF". Power off the instrument after
use. Instrument powers off about 3 min after the
last Key operation when the Function is "ON".
LCD indication disappears during recording due
to Power Save Function while recording is being
performed.
▼
▼