KYORITSU 5020 Instruction Manual - Manual (Page 17)

̶ 14 ̶
4. Check a Range/ Filter
Press the button to check their on/off
status.
Press the button to change them.
Independent setting of Range & Filter is
available on each CH.
Point
● At Normal Recording mode, Range and
Filter switches each time pressing the
button.
Auto-ranging is also available.
● At Trigger/Capture/Power Quality Analysis
modes, only Filter on/off is available.
Range is selected automatically based
on the detection level (preset value for
Trigger/ Capture Recording). See Setting1
"SEt.1".
● Setting change isn't available during
recording; setting should be done prior to
a recording.
mark means Range Hold Function is
activated.
mark means Auto-ranging Function is
activated.
5. When only the leftmost segment of the
Battery mark is flashing on the LCD, it
means battery voltage is low.
Replace the batteries with new ones.
When nothing is displayed on the LCD,
the batteries are exhausted. Replace the
batteries with new ones.
▼