KYORITSU 5020 Instruction Manual - Manual (Page 13)

̶ 10 ̶
Following explains the flow of operation: through preparation to the stop
of recording.
P.11
P.12
P.13
P.15
P.17
* The recorded data can be viewed either by the following two methods.
(1) On a PC: Follow the instruction described at "10. Data transfer to
PC" in this manual (P.43) for data transfer, and Help for PC Software
"KEW LOG Soft 2" for operation method.
(2) On the instrument: Refer to Confirmation of recorded data (CALL)
(P.39)
* Press the button at least 1 sec. to power off the instrument.
(This is because to prevent operational error.)
4. Recording procedures
▼
Step1: Start-up
Step2: Confirmation of the set value
▼
Step3: Preparation before recording
▼
Step4: Start of recoding
▼
Step5: Stop of recording
Select the appropriate sensor, and
connect it to the instrument.
Confirm the recording mode.
Install the instrument and do setups for
each channel.
Start recording.
Stop recording.