KYORITSU 5020 Instruction Manual - Manual (Page 26)

̶ 23 ̶
5. Detection level at CH1 is indicated.
Can be set at every 1 from 0 to 1000
◆ To change the setting, press the button.
Then the indication on the LCD flashes.
◆ Press the or button to set the
value to the desired one. Then press the
button to confirm it.
◆ When using Leakage Current Sensor, pressing
the button at 1000mA indication
changes to 2A, pressing the button at
2A indication changes to 1000mA (1A)
Point
Further detection doesn't start when a value falls
to 50% or less (for voltage sensor: 1% or more)
of the detected level. Set the appropriate value
based on the test prior to recording.
6. Confirm or change the preset current value on
channel 2 and 3 as well.
7. Next, One-time/ Endless is indicated.
One-time: Recording stops when memory
becomes full.
Endless : Overwrite the old data, and store
the latest data.
◆ Press the button and proceed to the
next step when not changing the setting.
◆ To change the setting, press the button.
Then the indication on the LCD flashes.
Press the or button to set
the value to the desired one. Then press the
button to confirm it.
▼
▼