KYORITSU 5020 Instruction Manual - Manual (Page 31)

̶ 28 ̶
◆ Flashing Detection LED
● LED on the Sensor connected channel blinks when following Trigger
is detected.
Trigger is detected when the measured values
exceed the pre-set detection level under Trigger/ Capture Recording
Mode.
Trigger is detected when the measured current
values exceed the pre-set detection level under Trigger/ Capture
Recording Mode and Power Quality Analysis Mode.
For voltage values, Trigger is detected when it is below the
detection level.
● LED flashes whenever the measured values exceed the pre-set
detection level during measurements.
● LED blinks every 4 sec during recordings after one detection
occurs. (When Auto-power off is OFF, it blinks every 2 sec.)
● To restore the blinking LED during recordings, first press the
button once and enters into Menu mode. Then press the
button to return Measurement mode.