Profibus settings – KROHNE MFC 400 Profibus User Manual
Page 53
PROFIBUS SETTINGS
5
53
MFC 400
www.krohne.com
06/2013 - 4002835301 - AD MFC 400 PROFIBUS R01 en
M
M Electronics
Mem. Life Exceeded
The number of maximum write
cycles is exceeded for EEPROM
or FRAM or Flash (if detected).
Exchange electronics assembly.
S
S Config:
Totaliser
Tot 1 FB4 Overflow
Counter FB4 had an overflow.
After the overflow it started
again at zero.
(not supported till now)
Check totaliser format.
Tot 2 FB5 Overflow
Counter FB5 had an overflow.
After the overflow it started
again at zero.
(not supported till now)
Tot 3 FB6 Overflow
Counter FB6 had an overflow.
After the overflow it started
again at zero.
(not supported till now)
I
I Electr: Power
Failure
Tot 1 FB4 Power
Failure
Totaliser 1 invalid due to power
failure.
Check Totaliser value. Reset
Errors (A3.1).
Tot 2 FB5 Power
Failure
Totaliser 2 invalid due to power
failure.
Tot 3 FB6 Power
Failure
Totaliser 3 invalid due to power
failure.
Power Failure
Detected
Power failure. Totalisers did not
run during that time.
Reset Errors (A3.1).
I
I Electr.
Operation Info.
PROFIBUS No Data
There is no cyclic data exchange
established in connection with
this MFC 400.
PROFIBUS Baudrate
The PROFIBUS RS485 interface
is looking for a baudrate
supported.
Check PROFIBUS terminal and
connection.
PROFIBUS Passivated
PROFIBUS module is passivated. Disable PROFIBUS passivation.
PROFIBUS Clear Data
PROFIBUS Clear Data active.
Start cyclic PROFIBUS
communication.
PROFIBUS Sync Mode
PROFIBUS Sync Mode active.
Disable Sync Mode.
PROFIBUS Freeze
Mode
PROFIBUS Freeze Mode active.
Disable Freeze Mode.
Tot 1 Stopped
Tot 1 FB4 has stopped.
Select "Totaliser Function" and
choose setting other than "Stop"
(C4.1.1)
Tot 2 Stopped
Tot 2 FB5 has stopped.
Select "Totaliser Function" and
choose setting other than "Stop"
(C4.2.1)
Tot 3 Stopped
Tot 3 FB6 has stopped.
Select "Totaliser Function" and
choose setting other than "Stop"
(C4.3.1)
Tot 1 FB4 Threshold
Tot 1 FB4 Threshold exceeded.
Reset Totaliser 1 FB4 (C4.1.4).
Tot 2 FB5 Threshold
Tot 2 FB5 Threshold exceeded.
Reset Totaliser 2 FB5 (C4.2.4)
Tot 3 FB6 Threshold
Tot 3 FB6 Threshold exceeded.
Reset Totaliser 3 FB6 (C4.3.4)