KROHNE MFC 400 Profibus - Manual (Page 43)

COMMISSIONING / OPERATION
4
43
MFC 400
www.krohne.com 06/2013 - 4002835301 - AD MFC 400 PROFIBUS R01 en
if condensed status and diagnosis condensed status and diagnosis condensed status and diagnosis condensed status and diagnosis handling selected:
Above mentioned definitions for both diagnosis and status will be internally used for PROFIBUS
diagnosis and status handling of the classifications stated above which will be possible for the
variable "Event groups".
if classic status and diagnosis classic status and diagnosis classic status and diagnosis classic status and diagnosis handling selected:
Above mentioned definitions for both diagnosis and status will be internally used for PROFIBUS
diagnosis and status handling of the classifications stated above which will be possible for the
variable "Event groups".
Enter menu:→ Online menu: "Device → Process Input(Online) → Diagnosis Mapping": or
→ Offline menu: "MFC400 -> Process Input -> Diagnosis Mapping":
"F" Failure diagnosis: DIA_MAINTENANCE_ALARM (Maintenance alarm (40))
status: BAD - maintenance alarm
"S" Out of specification diagnosis: DIA_MAINTENANCE_DEMAND (Maintenance demanded (41))
status: UNCERTAIN - process related, no maintenance
"M" Maintenance required diagnosis: DIA_MAINTENANCE (Maintenance required (37))
status: GOOD - maintenance demanded
"C" Function check diagnosis: DIA_FUNCTION_CHECK (Function check (42))
status: GOOD - function check
"I" Information diagnosis: NO DIAGNOSIS EVENTS (no diagnosis events) 1
status: GOOD - ok
1 Bit "EXTENSION_AVAILABLE" of parameter DIAGNOSIS will be set if at least one Bit of parameter "DIAGNOSIS_EXTENSION" has been
set.
"F" Failure diagnosis: DIA_HW_ELECTR (Hardware failure electronics (24))
status: BAD - Device Failure
"S" Out of specification diagnosis: DIA_MEASUREMENT (Measurement failure (29))
status: UNCERTAIN - sensor conver. not accur.
"M" Maintenance required diagnosis: DIA_MAINTENANCE (Maintenance required (37))
status: GOOD (NC) - maintenance required
"C" Function check diagnosis: NO DIAGNOSIS EVENTS (Status OK – function check only) 1
status: UNCERTAIN - simulated value (Function Check)
"I" Information diagnosis: NO DIAGNOSIS EVENTS (no diagnosis events) 2
status: GOOD - ok
1 "NO DIAGNOSIS EVENTS (Function Check only)".
2 Bit "EXTENSION_AVAILABLE" of parameter DIAGNOSIS will be set if at least one Bit of parameter "DIAGNOSIS_EXTENSION" has been
set.
CAUTION!
If using the EDD
EDD EDD EDD it is strongly recommended strongly recommended strongly recommended strongly recommended to use the following combinations only only only only for the below
mentioned classifications: