KROHNE OPTISYS SLM 2100 EN - Manual (Page 56)

5
OPERATION
56
OPTISYS SLM 2100
www.krohne.com 03/2014 - 4002737302 - MA OPTISYS SLM 2100 R02 en
Step 3: calibrate zero
The calibration zero is done.
• Press ^ ^ ^ ^ several time until you reach the measuring mode again. Choose yes yes yes yes to safe and
confirm your selection.
Step 3a: calibrate conc. with known reference value
Press or until the submenu calibrate zero calibrate zero calibrate zero calibrate zero is highlighted.
Press >>>> to enter the chosen menu.
actual value actual value actual value actual value is shown.
Press ^ ^ ^ ^ to enter the chosen menu.
calibrate zero calibrate zero calibrate zero calibrate zero is shown.
Press or to select calibrate calibrate calibrate calibrate to calibrate or break break break break to interrupt the calibration.
Press ^ ^ ^ ^ to enter the chosen menu.
Start the calibration process with step 2: move sensor
Press or until the submenu calibrate conc. calibrate conc. calibrate conc. calibrate conc. is highlighted.
Press >>>> to enter the chosen menu.
reference value reference value reference value reference value is shown.
Press or to enter the reference value.
Press ^ ^ ^ ^ to confirm the value.
ADC value ADC value ADC value ADC value is shown.
Press or to choose between stored value stored value stored value stored value to use the stored value or actual value actual value actual value actual value to use
the actual value for calibration.
Press or to select actual value actual value actual value actual value.
Press ^ ^ ^ ^ to enter the chosen menu.
actual value actual value actual value actual value is shown.
Press ^ ^ ^ ^ to confirm the value.
use value use value use value use value is shown.
Press or to choose between break break break break to interrupt the calibration,calibrate calibrate calibrate calibrate
to adjust the actual value to the reference value or save ADC value save ADC value save ADC value save ADC value to save
the actual value.
Press or to select calibrate calibrate calibrate calibrate
Press ^ ^ ^ ^ to enter the chosen menu.
Press ^ ^ ^ ^ several time until you reach the measuring mode again.
Choose yes yes yes yes to safe and confirm your selection.
.book Page 56 Wednesday, April 30, 2014 1:39 PM