KROHNE OPTISYS SLM 2100 EN - Manual (Page 50)

5
OPERATION
50
OPTISYS SLM 2100
www.krohne.com 03/2014 - 4002737302 - MA OPTISYS SLM 2100 R02 en
C5, device
Level Designation / function Settings / descriptions
This menu groups all functions that have no effect on the measurement or any output directly.
C5.1 Device info Information about the device.
C5.1.1 Device serial no. This menu shows the serial number of the device.
C5.1.2 Mainboard This menu gives information about the main board.
• 1st line: ID No. of the circuit board
• 2nd line: software version
• 3rd line: production date
C5.1.3 Sensor electronic This menu gives information about the main board.
• 1st line: ID No. of the sensor
• 2nd line: software version
• 3rd line: production date
C5.2 Display Groups several function for the fine adjustment of the display.
C5.2.1 Language Refer to A1 "language".
C5.2.2 Contrast This function allows to adjust the contrast of the display (e.g. at extreme
temperatures). Note that a change of the contrast takes place immediately,
not just when the menu mode is excited! You cannot reset a change when
leaving the programming mode without saving the changes!
Range: -9...+9
C5.3 Special functions This menu groups several special functions.
C5.3.1 Reset errors Refer to A3 "reset".
C5.3.2 Password quick set This function allows to define and activate a password for the access to the
quick setup menu. Options: XXXX (if you enter four digits in the range of
0001...9999, then the password protection is enabled) / 0000 (password
protection disabled)
C5.3.3 Password setup This function allows to define and activate a password for the access to the
setup menu. Options: XXXX (if you enter four digits in the range of
0001...9999, then the password protection is enabled) / 0000 (password
protection disabled)
.book Page 50 Wednesday, April 30, 2014 1:39 PM