KROHNE OPTISYS SLM 2100 EN - Manual (Page 14)

3
INSTALLATION
14
OPTISYS SLM 2100
www.krohne.com 03/2014 - 4002737302 - MA OPTISYS SLM 2100 R02 en
Installation
3.1 General notes on installation
3.2 Storage and transport
• Store and transport the device in a dry, dust-free environment.
• Store and transport the device in an environment with a temperature between 0...+60°C /
+32...+140°F.
• The original packing is designed to protect the equipment. It has to be used if the device is
transported or sent back to the manufacturer including the sensor transportation packing, to
prevent damage of the sensor.
INFORMATION!
Inspect the packaging carefully for damages or signs of rough handling. Report damage to the
carrier and to the local office of the manufacturer.
INFORMATION!
Do a check of the packing list to make sure that you have all the elements given in the order.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
INFORMATION!
The display should be mounted in a height of 1.5...1.8 m / 4.9...5.9 ft to prevent ergonomic
hazards.
INFORMATION!
During work on the device above the basin the personnel have to be protected by personal safety
equipment.
INFORMATION!
Due to the weight above 20 kg / 44.1 lbs please lift and carry the device only with two persons or
use approbiate lifting equipment and if the surfaces of the device are wet, please use gloves for
lifting.
.book Page 14 Wednesday, April 30, 2014 1:39 PM