KROHNE OPTISYS SLM 2100 EN - Manual (Page 39)

OPERATION
5
39
OPTISYS SLM 2100
www.krohne.com 03/2014 - 4002737302 - MA OPTISYS SLM 2100 R02 en
5.4 Measuring page
After switching on the power, the display always shows the measuring page. Right beside all
measuring results you see the corresponding unit at the end of the line. Only if there is no unit
available it is left out (this is only the case with the diagnosis values).
The following drawing shows an example of the measuring page in the measuring mode "Level":
Pressing ↑ will bring you to the status page.
If profile mode is applied, a second measuring page can be choosen, presenting the profile of the
measurement as bar plot.
INFORMATION!
•
Always push the keys at right angles to the front. Touching them from the side can cause
incorrect operation!
• After 5 minutes of inactivity in the menu mode, there is an automatic return to the measuring
mode. In this case the device does not save previously changed data!
Figure 5-2: Example of the measuring page
.book Page 39 Wednesday, April 30, 2014 1:39 PM