KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.63 through 3.86 - Manual (Page 76)

B-14
SERIES EL 070312
B.84 SYSTem:FAN COMMAND
SYST:FAN
Syntax: Short Form: SYST:FAN Long Form: SYSTem:FAN
Where = integer, either 0 or 100
Description: SYST:FAN 0 sets fan to off. SYST:FAN 100 sets fan to on.
B.85 SYSTem:FAN? QUERY
SYST:FAN?
Syntax: Short Form: SYST:FAN? Long Form: SYSTem:FAN?
Returns = 0 or 100
Description: Indicates fan status: 0 = off, 100 = on.
B.86 0SYSTem:PFModule:DAMPing COMMAND
SYST:PFM:DAMP
Syntax: Short Form: SYST:PFM:DAMP Long Form: SYSTem:PFModule:DAMPing
Where = integer from 0 (minimum damping) to 5 (maximum damping)
Description: Establishes damping settings for Power FET Modules. Increased damping decreases the loop's
response time to transients. Factory default setting is 3.
Damping Settings: 0 - 1nF, 1 - 4.3nF, 2 - 11nF, 3 - 34nF, 4 - 101nF, 5 - 147.3nF. See PAR. 3.14 for
details.
B.87 SYSTem:PFModule:DAMPing? QUERY
SYST:PFM:DAMP?
Syntax: Short Form: SYST:PFM:DAMP? Long Form: SYSTem:PFModule:DAMPing?
Returns = integer from 0 (minimum damping) to 5 (maximum damping)
Description: Indicating damping settings for Power FET Modules. See PAR. 3.14 for details.
B.88 SYSTem:PFModule:LIST? QUERY
SYST:PFM:LIST?
Syntax: Short Form: SYST:PFM:LIST? Long Form: SYSTem:PFModule:LIST?
Description: List Power FET Modules within chassis (see below for example).
SYST:PFM:LIST?
KEPCO, EL 5K-200-600 01-18-2010,A999104,MCB #200 1.176 $ 2010/01/18 22:27:06 $
6 Power FET Modules Installed
Pos Serial Revision
0 292 1.39
1 293
2 294 1.39
3 310 1.39
4 1200 1.39
5 296
NOTE: PFMs with no revision are using Firmware Revisions below 1.35.