beautypg.com

B.78 system:communicate:lan:subnetmask? query, B.79 system:damping command, B.80 system:damping? query – KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.63 through 3.86 User Manual

Page 75: B.81 system:error? query, B.82 system:external command, B.83 system:external? query, B.78, System:communicate:lan:subnetma, B.79, System:damping command

background image

SERIES EL 070312

B-13

B.78 SYSTem:COMMunicate:LAN:SUBNetmask? QUERY

SYST:COMM:LAN:SUBN

?

Syntax:

Short Form: SYST:COMM:LAN:SUBN?
Long Form: SYSTem:COMMunication:LAN:SUBNetmask?
Returns: = numbers from 0 to 255 comprising the Subnet Mask

Description: Returns the Subnet Mask used during LAN communication.

B.79 SYSTem:DAMPing COMMAND

SYST:DAMP

Syntax:

Short Form: SYST:DAMP x

Long Form: SYSTem:DAMPing x

Where x = integer from 0 (minimum damping) to 7 (maximum damping)

Description: Inserts capacitance required to damp oscillation. Increased damping reduces the tendency for

oscillation and reduces response time to high speed transients. Units are shipped from the factory set
to 4. See PAR. 3.14 for details. Older units only accept settings from 0 to 5. This can be determined
by sending SYST:DAMP 6 and then SYST:DAMP? - if the query returns 6, the unit will accept a maxi-
mum of 7; if the query returns 5, the maximum setting is 5.

B.80 SYSTem:DAMPing? QUERY

SYST:DAMP?

Syntax:

Short Form: SYST:DAMP?

Long Form: SYSTem:DAMPing?

Returns x where x = integer from 0 (minimum damping) to 7 (maximum damping)

Description: Returns the damping setting established by SYST:DAMP (PAR. B.79). See PAR. 3.14 for an

explanation of damping. See PAR. B.79 to determine whether the unit will accept a maximum setting
of 5 or 7.

B.81 SYSTem:ERRor? QUERY

SYST:ERR?

Syntax:

Short Form: SYST:ERR?

Long Form: SYSTem:ERRor?

Description: Returns next entry from the error message queue. Responds with the most recent error message

in a queue of up to 10 possible messages and clears each error message as it is sent. Issuing *CLS
clears all error messages in the queue.

Error Message

Code

Command Error Generic -100
Invalid Separator

-103

Illegal Parameter Value

-224

Invalid Unit Number

-241

Queue Overflow

-350

No Error

-0

B.82 SYSTem:EXTernal COMMAND

SYST:EXT

Syntax:

Short Form: SYST:EXT

Long Form: SYSTem:EXTernal

where = 0 or OFF for disable, 1 or ON for enable

Description: Enables or disables external analog programming.

B.83 SYSTem:EXTernal? QUERY

SYST:EXT?

Syntax:

Short Form: SYST:EXT?

Long Form: SYSTem:EXTernal?

Returns: = 0 (disabled) or 1 (enabled)

Description: Indicates whether external analog programming is enabled or disabled.