GW Instek GDS-1000 Series Programming Manual - Manual (Page 27)

COMMAND DETAILS
53
Example :trigger:type 2
:trigger:pulse:time 1
Selects the pulse trigger
and sets the trigger
time as 1sec
88B
:TRIGger:REJect
Set
Query
Description Selects the trigger rejection filter.
Same as: Trigger key → F4 → F3
Syntax < Long > < Short >
:trigger:reject
:trigger:reject?
:trig:rej
:trig:rej?
Parameter Rejection filter
0 off
1 LF
2 HF
Note Before using this command, select the edge or
pulse trigger. See the example below.
Example :trigger:type 0
:trigger:reject 1
Selects the edge trigger
and LF rejection filter
89B
:TRIGger:SLOP
Set
Query
Description Selects the trigger slope.
Same as: Trigger key → F4 → F1
Syntax < Long > < Short >
:trigger:slop
:trigger:slop?
:trig:slop
:trig:slop?
Parameter Trigger slope
0 + (positive)
GDS-1000 Programming Manual
54
1 – (negative)
Note Before using this command, select the edge or
pulse trigger. See the example below.
Example :trigger:type 0
:trigger:slop 1
Selects the edge trigger
and negative trigger
slope
90B
:TRIGger:SOURce
Set
Query
Description Selects the trigger source channel.
Same as: Trigger key → F2
Syntax < Long > < Short >
:trigger:source
:trigger:source?
:trig:sour
:trig:sour?
Parameter Trigger source Trigger source
0 Channel 1 2 Line
1 Channel 2 3 External input
Example :trigger:source 0 Selects Channel 1 as the
trigger source
91B
:TRIGger:TYPe
Set
Query
Description Selects the trigger type.
Same as: Trigger key → F1
Syntax < Long > < Short >
:trigger:type
:trigger:type?
:trig:typ
:trig:typ?
Parameter Trigger type Trigger type
0 Edge 2 Pulse