GW Instek GDS-1000 Series Programming Manual - Manual (Page 14)

COMMAND DETAILS
27
36B
:CURSor:SOURce
Set
Query
Description Selects or returns the cursor source channel.
Same as: Cursor key →F1 (Source)
Syntax < Long > < Short >
:cursor:source
:cursor:source?
:curs:sour
:curs:sour?
Parameter Cursor source channel
1/2 Channel ½
3 Math result
Example :cursor:source 2 Selects Channel 2 as
the cursor source
GDS-1000 Programming Manual
28
10B
Display Command
:DISPlay:ACCumulate ..................................................
219H
28
:DISPlay:CONTrast......................................................
220H
28
:DISPlay:GRATicule .....................................................
221H
29
:DISPlay:WAVeform.....................................................
222H
29
:REFResh......................................................................
223H
30
37B
:DISPlay:ACCumulate
Set
Query
Description Turns the display accumulate mode on/off or
returns its status.
Same as: Display key → F2
Syntax < Long > < Short >
:display:accumulate
:display:accumulate?
:disp:acc
:disp:acc?
Parameter Display accumulation
0 off
1 on
Example :display:accumulate 1 Turns on the
accumulation
38B
:DISPlay:CONTrast
Set
Query
Description Sets or returns the display contrast level.
Same as: Display key → F4
Syntax < Long > < Short >
:display:contrast
:display:contrast?
:disp:cont
:disp:cont?