GW Instek GDS-1000 Series Programming Manual - Manual (Page 17)

COMMAND DETAILS
33
Description Returns the frequency value.
Same as: Measure key → F1~F5 → F3 (Frequency)
Syntax < Long > < Short >
:measure:frequency? :meas:freq?
Returns
Note Before using this command, select the
measurement channel. See the example below.
Example :measure:source 1
:measure:frequency?
Selects Channel 1, and
then measures the
frequency.
46B
:MEASure:NWIDth Query
Description Returns the first negative pulse width timing.
Same as: Measure key → F1~F5 → F3 (–Width)
Syntax < Long > < Short >
:measure:nwidth? :meas:nwid?
Returns
Note Before using this command, select the
measurement channel. See the example below.
Example :measure:source 1
:measure:nwidth?
Selects Channel 1, and
then measures the
negative pulse width.
47B
:MEASure:PDUTy Query
Description Returns the positive duty cycle ratio.
Same as: Measure key → F1~F5 → F3 (DutyCycle)
Syntax < Long > < Short >
:measure:pduty? :meas:pdut?
Returns as the percentage
GDS-1000 Programming Manual
34
Note Before using this command, select the
measurement channel. See the example below.
Example :measure:source 1
:measure:pduty?
Selects Channel 1, and
then measures the
positive duty cycle.
48B
:MEASure:PERiod Query
Description Returns the period.
Same as: Measure key → F1~F5 → F3 (Period)
Syntax < Long > < Short >
:measure:period? :meas:per?
Returns
Note Before using this command, select the
measurement channel. See the example below.
Example :measure:source 1
:measure:period?
Selects Channel 1, and
then measures the
period.
49B
:MEASure:PWIDth Query
Description Returns the first positive pulse width.
Same as: Measure key → F1~F5 → F3 (+Width)
Syntax < Long > < Short >
:measure:period? :meas:per?
Returns
Note Before using this command, select the
measurement channel. See the example below.
Example :measure:source 1
:measure:pwidth?
Selects Channel 1, and
then measures the
positive pulse width.