GW Instek GPD-4303S - Manual (Page 47)

REMOTE CONTROL
e Command not
allowed
The entered command is not allowed in the
circumstance. Example: trying to set CH2
output while in the tracking mode.
f Undefined header The entered command does not exist, or the
syntax is wrong.
Command List
• Detailed descriptions of each command start from the next page.
• The “HELP” command shows all the below commands and their
meanings, except for the HELP command itself.
ISET: Sets the output current.
ISET? Returns the output current setting.
VSET: Sets the output voltage.
VSET? Returns the output voltage setting.
IOUT? Returns the actual output current.
VOUT? Returns the actual output voltage.
TRACK Selects the operation mode.
BEEP Turn on or off the beep.
OUT Turn on or off the output.
STATUS? Returns the GPD-X303S status.
*IDN? Returns the GPD-X303S identification.
RCL Recalls a panel setting.
SAV Saves the panel setting.
HELP? Shows the command list.
ERR? Returns the instrument error messages.
BAUD Sets the baud rate.
LOCAL Returns the instrument to local mode.
47