GW Instek GPD-4303S - Manual (Page 36)

GPD-X303S Series User Manual
1. Press the SER/INDEP key to
activate the tracking series
mode. The key LED turns
on.
2. Connect the load to the front panel terminals,
CH1+ & CH2−. Use the CH1 (−) terminal as the
common line connection.
Note: this diagram shows non-European
terminals.
3. Press the CH1 key (LED
turns on) and use the
Voltage knob to set the
master & slave output
voltage (the same level for
both channels).
By default, the Voltage and
Current knob work in the
coarse mode. To activate the
fine mode, press the knob to
turn the FINE LED on.
(master & slave)
(Fine control)
• Coarse: 0.1V or 0.1A for each step
• Fine: 1mV or 1mA for each step
4. Use the Current knob to set
the master output current.
36