GW Instek PSM-Series Programming Manual - Manual (Page 26)

PSM SERIES PROGRAMMABLE POWER SUPPLY
PROGRAMMER MANUAL
⎯ 49 ⎯
z SYSTEM COMMANDS
SYSTem:ERRor?
Function:
Query the next error message from the Error/Event queue. The result of the
query is the error number followed by the error text.
Syntax:
SYSTem:ERRor?
Returns:
Examples:
SYSTem:ERRor? returns 0, “No error”
SYSTem:MEMory?
Function:
Read the current memory section number displayed on the panel
.
Syntax:
SYSTem:MEMory?
Returns:
The range is from 0 through 99.
SYSTem:VERSion?
Function:
Return the SCPI version of the device.
Syntax:
SYSTem:VERSion?
PSM SERIES PROGRAMMABLE POWER SUPPLY
PROGRAMMER MANUAL
⎯ 50 ⎯
Returns:
1994.0
SYSTem:BEEPer:STATe
Function:
Set or query the currently beeper state.
Syntax:
SYSTem:BEEPer:STATe {0|1|OFF|ON}
SYSTem:BEEPer:STATe?
Examples:
SYSTem:BEEPer:STATe ON set beeper state on.
SYSTem:BEEPer
Function:
To issue a single beep immediately.
Syntax:
SYSTem:BEEPer
z RS-232 INTERFACE COMMANDS
SYSTem:LOCal
Function:
This command is to set the power supply to the local mode. During the
operation of RS-232, all control knobs on the front panel are enabled.
Syntax:
SYSTem:LOCal