GW Instek PSM-Series Programming Manual - Manual (Page 13)

PSM SERIES PROGRAMMABLE POWER SUPPLY
PROGRAMMER MANUAL
⎯ 23 ⎯
Examples:
*IDN? Returns GW.Inc,PSM-2010,A1234567,FW1.00
*OPC
Function:
The command form (*OPC) sets the operation complete bit (bit 0) in the
Standard Event Status Register (SESR) when all pending operations are
finished.
The query form (*OPC?) tells the programmable power supply to place an
ASCII 1 in the Output Queue when the power supply completes all pending
operations.
Syntax:
*OPC
*OPC?
Returns:
1
*RCL
Function:
Recall the setting data from the memory saved previously.
Syntax:
*RCL
is in the range from 0 through 99.
Examples:
*RCL 12 recalls the setting data stored in memory location 12.
PSM SERIES PROGRAMMABLE POWER SUPPLY
PROGRAMMER MANUAL
⎯ 24 ⎯
*RST
Function:
Set all control settings of power supply to their default values but does not
purge stored setting. The equivalent panel control will be set as below:
Front Panel Control Default Setting
OUTPUT OFF
CURRENT SET
CURRENT TRIGGER
PSM-2010:20.000A
PSM-3004:7.000A
PSM-6003:6.000A
VOLTAGE SET
VOLTAGE TRIGGER
0
DELAY 0.1 sec
OCP DELAY 0 sec
AUTO SET OFF
RECALL (memory location) 00
OVP SET
PSM-2010:22.000V
PSM-3004:32.000V
PSM-6003:65.000V
OCP SET
PSM-2010:22.000A
PSM-3004:7.700A
PSM-6003:6.600A
STEP SET 0.001V,0.001A
RECALL RANGE
START 00
CEASE 99
CYCLE 2