GW Instek GOS-6000 Series - Manual (Page 4)

GOS-6051/6050/6031/6030 OSCILLOSCOPE
USER MANUAL
⎯ 2 ⎯
1-2.Features
Additionally, the oscilloscope offers several other features:
1) High intensity and internal graticule CRT
The oscilloscope employs a high intensity 6-inch retangular type cathode-
ray tube with red internal graticule. It displays clear readable traces even at
high sweep speeds. Internal graticule lines eliminate parallax-viewing error
between the trace and the graticule line.
2) Frequency Counter (GOS-6051/6031)
A built-in 6 digits frequency counter is accurate within the range of ±
0.01% measuring frequency between 1kHz to 30/50MHz and ±0.05%
measuring 50Hz to 1kHz.
3) ALT-MAG Function
The primary sweep waveform along with the magnified sweep waveform
can be displayed simultaneously using the ALT-MAG function. The
magnification ratio can be selected from among three stages of Ч5, Ч10, Ч
20 for magnifying the displayed waveform in the center of the CRT.
4) Convenient VERT-MODE Triggering
The sync signal source is decided automatically when vertical axis mode is
switched. This means that you need not change the trigger source every
time you switch the VERT-MODE.
5) TV triggering
Exclusive TV sync separator circuit technology provides stable TV signal
measurements on fields, frames and lines.
6) Hold Off
The function allows the obtaining of stable synchronization for even
complex waveforms that are difficult to synchronized by adjusting the
trigger level alone.
GOS-6051/6050/6031/6030 OSCILLOSCOPE
USER MANUAL
⎯ 3 ⎯
7) CH1 Signal Output
The CH1 signal output is obtained by branching the input signal in the
middle of the signal line. As the connector outputs the input signal at a
rate of 50mV/div, connecting a frequency counter makes it possible to
measure the frequency of a very low signal while observing its waveform.
8) Z-axis intensity modulation
For applying a blanking signal from an external source. The trace displayed
on the screen may be intensity-modulated where pulse signal or time-scale
marks are required.
9) LED indicator and buzzer alarm
The LED’s located in the front panel assist operation and indicated
additional information. Incorrect operation and the electrical end position
of control knobs are indicated by a warning beep.
10) SMD manufacturing technology
The instrument is built by using the most advanced SMD technology so as
to reduce the number of internal wiring and shorten the foil route on the pc
board. This will also greatly increase the high frequency performance and
the reliability of the product.
11) Compact size (275W×130H×370D)mm and front panel layout groups for easy-
to-use.