AT&T TL86109 - Manual (Page 67)

61
Telephone settings
Answering system settings
In the answering system setup menu, you can change the settings for call
screening, number of rings, remote access code, message alert tone and
recording time.
Call screening
The call screening feature lets you listen to a caller leaving a message at the
telephone base. While monitoring an incoming message, you can answer the
call by pressing
1 LINE/
FLASH
, 2 LINE/
FLASH
or /SPEAKER on the handset
to answer the incoming call, or pressing 1 LINE, 2 LINE or SPEAKER on
the telephone base, or using the corded handset to answer the incoming call .
To change the setting:
Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
Press
DIR, CID , /DELETE or /REC to highlight
Answering sys, then press the SELECT softkey.
Press
DIR, CID , /DELETE or /REC to choose
Mailbox 1 or Mailbox 2, then press the SELECT softkey.
Press
DIR, CID , /DELETE or /REC to highlight
Ans sys setup, then press the SELECT softkey.
Press the
SELECT softkey again to select
Call screening.
Press
DIR, CID , /DELETE or /REC to choose
On or Off, then press the SET softkey. You hear a
confirmation tone.
NOTE: For more information on call screening, see page 119.
1.
2.
3.
4.
5.
6.
ANSWERING SYS
Mailbox 1
Mailbox 2
SELECT
ANS SYS SETUP
Call screening
# of rings
Remote code
SELECT
MAILBOX 1
Record memo
Answer On/Off
Ans sys setup
SELECT
CALL SCREENING
On
Off
SET