AT&T TL86109 - Manual (Page 17)

11
Getting started
Battery installation and charging
Install the battery as shown below.
IMPORTANT INFORMATION:
Use only the supplied rechargeable battery or replacement battery (model BT184342/
BT284342). To order, visit our website at
www.telephones.att.com
or call
1 (800) 222-3111
. In Canada, dial
1 (866) 288-4268
.
If you do not use the handset for a long time, disconnect and remove the battery to prevent
possible leakage.
1.
2.
To replace the battery, press the tab and slide the
battery compartment cover downwards. Lift out the old
battery and disconnect it from the handset. Follow the
instructions above to install and charge the new battery.
Step 3
Charge the handset by
placing it face up in the
charger. The
CHARGE
light is on when
charging.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment, matching
the color-coded label.
Insert the supplied
battery with the label
THIS SIDE UP facing up
as indicated. Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.
CHARGE light
SET DATE
--/--/--
MM/DD/YY
BACK SET
SET TIME
--:-- --
BACK SET
After you install your telephone or power returns
following a power outage, the handset will prompt you to
set the date and time. For instructions, see
Set date/time
on page 37. To skip setting the date and time, press
OFF/CLEAR.