AT&T TL86109 - Manual (Page 54)

48
Telephone settings
Telephone base settings
Use caller ID to automatically set date and time
You can turn this feature on so that the date and time are set automatically
by incoming caller ID information.
Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
Press
DIR, CID , /DELETE or /REC to highlight
Settings, then press the SELECT softkey.
Press
DIR, CID , /DELETE or /REC to highlight
Set date/time, then press the SELECT softkey.
Press
DIR, CID , /DELETE or /REC to select
CID time sync, then press the SELECT softkey.
Press
DIR, CID , /DELETE or /REC to select
On or Off, then press the SET softkey to confirm. You
hear a confirmation tone.
Dial mode
The dial mode is preset to tone dialing. If you have pulse (rotary) service, you
must change the dial mode to pulse dialing before using the telephone.
To change the setting:
Press the MENU softkey on the telephone base in idle
mode to enter the main menu.
Press DIR, CID , /DELETE or /REC to highlight
Settings, then press the SELECT softkey.
Press DIR, CID , /DELETE or /REC to highlight
Dial mode, then press the SELECT softkey.
Press DIR, CID , /DELETE or /REC to choose
Tone or Pulse, then press the SET softkey to confirm.
You hear a confirmation tone.
NOTE: While you are on a call in pulse dialing mode, press TONE to temporarily change
to tone dialing mode.
1.
2.
3.
4.
5.
1.
2.
3.
4.
SETTINGS
Display alerts
Key tone
Set date/time
SELECT
SET DATE/TIME
Date/time
CID time sync
SELECT
CID TIME SYNC
On
Off
SET
SETTINGS
Key tone
Set date/time
Dial mode
SELECT
DIAL MODE
Tone
Pulse
SET