Fire-Lite IPDACT Installation Manual - Manual (Page 42)

IPDACT Module - Configuration
IV-39
Doc.Dm373-I
Rev. 2.0
IPDACT IP address and mask 01
IPDACT access gateway 02
IPDACT account number 11
Main VisorAlarm IP address 12
Backup VisorAlarm IP Address 21
UDP Port 13
b) If you have a DHCP server
Type of register Register
IPDACT account number 11
Main VisorAlarm IP address 12
Backup VisorAlarm IP Address 21
UDP Port 13
After configuring these parameters and restarting the device, the installer
must re-access the telephonic console as previously described and access
register 04. Here the installer password configured in the VisorALARM must
be configured. If the IPDACT has IP connectivity with the VisorALARM and
the password is correct, the IPDACT will receive the configuration defined in
the profile configured in the VisorALARM.
Through this mechanism, the installed IPDACT is registered in the Teldat
VisorALARM which from this point begins to monitor the former and the
IPDACT receives the necessary configuration in order to exchange
information with the Teldat VisorALARM.
If the whole process has gone smoothly, the IPDACT will begin to exchange
monitoring messages with the VisorALARM and from this point onwards the
IPDACT telephone relays activate (the line status LED lights up).
IV - 3.1.4. Configuration Example
In cases of configuring the IPDACT with the following data:
IP address: 192.168.1.100, mask 255.255.255.0
Access GW: 192.168.1.20
IPDACT account number: 1234
Main VisorAlarm IP: 10.24.6.1
Backup VisorAlarm IP: 80.6.189.123
UDP port: 3000
The registers and the data are, in cases where the testing digit is disabled
(through register 49):