Fire-Lite IPDACT Installation Manual - Manual (Page 23)

IPDACT Module – Installationg and cabling
III-20
Doc.Dm373-I
Rev. 2.0
cases of UL listed fire installations (UL864) the conduits must be able
to bear any attempts of mechanical injury.
8. The power cables +12V/+24V and GND, from the TO-AP and
FROM-AP telephone, the OUT-NO and the cable connected to the
box earthed ground (T1) leave through an opening and are fed
through a conduit in order to reach the panel.
9. The PSTN and PHONE telephone wires can also enter through the
opening indicated in point 9, if the said cables come from the panel.
10. The Ethernet cable can also enter through the opening indicated in
point 9 if it comes from the panel. The Ethernet cable must be a
CAT 5.
III - 2. Wiring
III - 2.1. Wiring for UL Listed Fire Installations
III - 2.1.1. Installation scheme
The IP module can be used in UL Listed fire installations provided that any of
the fire panels, listed in the appendix, section V.2, are used and the following
mandatory assembly is carried out: