Fire-Lite IPDACT Installation Manual User Manual

Page 41

IPDACT Module - Configuration

IV-38

Doc.Dm373-I

Rev. 2.0

The register is made up of four fields corresponding to the 4 numbers of the IP
address; this admits values between 0 and 255. Each number has a verification
digit. The default value is:

Alarm encryption key for the IPDACT to the maintenance receiver

This is the key used by the IPDACT to send alarms to the Teldat maintenance
VisorALARM. So the configuration is valid, this must be repeated twice.

The registrar consists of one field with up to 16 DTMF digits. By default, no value
is configured.

Installation key for remote configuration automatic request

This key is used to encrypt the remote configuration request packet. This manner
of request is automatic, e.g., the IPDACT sends a request packet until a remote
configuration was received from the VisorALARM+.

In the case of the installation key was empty the automatic request process will be
terminated, if existed.

The register is composed of one field containing up to 16 DTMF digits. By default
there is no configured value.

Using the testing digits

In order to increase the reliability of the telephonic console, some registers require
an additional testing digit in each of their fields so that if the control digit does not
adjust to the introduced value, the data is considered invalid and an error tone is
emitted. This facility can be enabled or disabled through this register.

The register is made up of a single digit field which admits a value of 1 to activate
the use of the testing digits and value 0 to deactivate. The fields contain a
verification digit for the number. Default value is 0.

IV - 3.1.3. Minimum configuration for the installer

By using the configuration patterns in the Teldat VisorALARM, you can
simplify the IPDACT installation process. So that the whole of the process is
possible, it is essential that there is a configuration pattern configured in the
VisorALARM. In the pattern, an installer password is associated to a given
IPDACT configuration. This configuration includes the passwords through
which information is exchanged between the IPDACT and the VisorALARM,
monitoring time, etc.

The minimum configuration for an IPDACT which permits an installer to use
this installation mechanism is as follows:

a) If you do not have a DHCP server

Type of register

000