Fire-Lite 411UDAC Fire Alarm Communicator - Manual (Page 35)

411UDAC Manual — P/N 51073:E 9/20/2013 35
Program Mode Modes of Operation
The user must program the primary and secondary phone numbers, account numbers, 24-hour test
report times and verify event codes for each Central Station account. The 411UDAC is shipped
with the program options/features already factory programmed. Alternative options/features may
be programmed if desired. If all factory default settings are acceptable, programming is complete.
Program Mode is entered by pressing the MODE key followed by the 4-digit program mode entry
code 7764 and pressing the [ENTER/STORE] key. Accessing this mode requires authentication.
Refer to Section 3.2.
– 7764 spells PROG on a Touch-Tone ® phone.
If an incorrect key is entered, reenter the proper 4-digit code before pressing the
[ENTER/STORE] key. Note that as information is entered into the 411UDAC, the digits will
scroll across the Programmer display from right to left.
___7
__77
_776
7764
A pause of up to 10 seconds between each number is allowed while entering the code. After press-
ing the [ENTER/STORE] key, the 411UDAC will be in Program Mode. A maximum of 10 min-
utes idle time is allowed at this point before beginning program entries and between each key
stroke, otherwise, the unit will return to Normal Mode. All entries made prior to the 10 minute
time-out are valid and are stored.
Once in Program Mode, the 411UDAC will:
 Light the DACT Trouble LED
 Activate Relay if programmed for DACT trouble
 Ignore all other keys other than those mentioned in this section
 Display 00_F on the Programmer display
 Continue to communicate any events not previously acknowledged at a central station prior
to entering Programming Mode
 Communicate an 'Off Normal' event to the Central Station
 Turn off piezo
While in Program Mode, the first three locations on the left of the Programmer display represent
the memory address and the last location (farthest right) represents the contents of the memory
address. The first address displayed is shown below:
Certain program items will be locked from editing if the communicator is active (dialing, transmit-
ting, etc.). These programming locations are ‘00-19’ Primary Central Station Phone Number, ‘20’
Primary Central Station Communications Format, ‘21-24’ Primary Central Station Account Code,
‘30-49’ Secondary Central Station Phone Number, ‘50’ Secondary Central Station Communica-
tions Format, ‘51-54’ Secondary Central Station Account Code, ‘61’ Central Station Backup
Reporting and ‘145-end’ Event Codes.
To unlock these locations, either wait until the communicator stops transmitting or disable the com-
municator via address location 64 by changing the content of this address to ‘0.’
When desired changes have been completed, exit Programming Mode by pressing the MODE key,
followed by the 4-digit code for an alternate mode and then the [ENTER/STORE] key. During
Program Mode, if no key is pressed within 10 minutes, the unit will revert to Normal Mode.
00_F
(address) (data)