Aquametrix 2300 Multi-Input Controller User Manual User Manual
Page 37
N116-133 AquaMetrix 2300 Installation and Operation Manual
Page 37
10.2. Web Server and TFTP Server Setups
The second submenu is the Web Server Setup, which allows the setting of the internal web
server port as well as enabling or disabling the access log and error log. If the web server port
is changed, the AquaMetrix 2300 must be restarted for this change to take effect.
The third submenu is the TFTP Server Setup. This configuration page allows the setting of
the internal TFTP server configuration. The TFTP Server should not be enabled under normal
operation, as it is a potential security risk. If the TFTP server is disabled or the port is changed
after it is started, the 2300 must be restarted to take effect.
10.3. Email Setup
The fourth submenu is Email Setup. It is necessary to setup email addresses, SMTP server, and
stock email messages. The 2300 is preconfigured with an SMTP server entry suitable for
sending emails and alerts along a network. The email sender is
. If
you want to set up sending from your own email account, talk to your IT department or follow
the directions below. Note that the 2300 internal web server does not support SSL security
protocol, so you may have to establish a third party email provider such as juno.com to
generate the emails.
To change the email server, select Setup > Network Setup > Email Setup > SMTP
Connection Setup. The SMTP Connection Wizard is shown below in Figure 27. The two
required configuration values are the SMTP server address and the SMTP port. The SMTP
server address can be entered as a DNS name (for example SMTP.mycompany.com) or an IP
address (192.168.2.200). The SMTP port is a number that is assigned by your IT department; we
use 587 for juno.com. You should get both of these values from your IT department. The
Global From Address will be used in all email messages as the sending email address (e.g.
[email protected]). You also need to enter email addresses, optionally enter form
emails to use later, and send a test email.
Some SMTP servers require authentication and if it does, you must check the appropriate
checkbox on this form and also fill in the user name and password information on the next
page.