Aquametrix 2300 Multi-Input Controller User Manual - Manual (Page 14)

N116-133 AquaMetrix 2300 Installation and Operation Manual Page 14
Wiring of a pulse rate sensor is shown below in Figure 7. The three wires from a typical
unpowered probe are +, -, and signal.
Figure 7 - Configuring a flow sensor (paddle wheel or magmeter) to one of the pulse input
connections.
3.3. Probe Configuration Setup
The Probe Configuration menu screen is shown in Figure 8. This screen appears in the web
menu at Setup/Probe Configuration. This screen is used to enable or disable individual probes,
to set up the order that the probes are displayed on both the front panel and web, to delete
old probes, and to add or substitute new probes to the controller. Eight slots are listed, which
is the order that the 2300’s software keeps track of the probes. Each slot may be configured as
analog, digital, or virtual probes. Slot # refers to the position on the front panel and web
Probe Status displays.