Triton RL5000XP PC-BASED ATMS Installation Manual - Manual (Page 47)

47
NMD-100 D
IsPENsING
M
ECHaNIsM
R
EMOvaL
/I
NsTaLLaTION
5. Connect the AC power cable to
the dispenser power supply (Fig-
ure 5). Route the shutter, data, and
power cables through the cable
clips.
6. Disengage the slide rails by lift-
ing up/down on the locking lever
located in Figure 6 (both sides).
Slide the dispenser into the cabi-
net until the slide rail locking pin
is engaged. (Figure 7)
7. Turn the dispenser power switch
located just to the right of the
power connector to ON (I).
Figure 7. Slide dispenser into cabinet.
4. Refer to Figure 4. Connect the
serial communication data cable
and the shutter cable to the con-
nectors on the left side of the dis-
penser. For the serial data cable,
use the forward -most connector
as shown. The plug is keyed to
ensure proper installation.
Figure 5. AC power cable connection.
Figure 4. Shutter and data cable
connectors.
Figure 6. Disengage slide rails.
Shutter cable
connector
Serial cable
connector
AC power cable connector