Atm e – Triton RL5000XP PC-BASED ATMS Installation Manual User Manual
Page 18
18
aTM E
NvIRONMENTaL
P
RECaUTIONs
C
HECkLIsT
TEMPERATURE/HUMIDITY
1. The ATM needs to be in an
environmentally-controlled
location, with no extreme fluc-
tuations in temperature or
humidity.
Generally, these parameters
must fall within the following
ranges:
Temperature
• 10-40 Deg. C
• 50-104 Deg. F
Relative Humidity
• 20% - 80%
• (Non-Condensing)
AC POWER REQUIREMENTS
2. Ensure the following AC power
requirements are met:
Isolated Ground. An equipment
grounding conductor that is insulated
from the conduit or raceway and all
other grounding points throughout
its entire length. The only points of
electrical connection will be at the
duplex outlet and service panel ends
of the line.
Dedicated source. The ATM AC
power feed will be a dedicated line, to
which no other electrical devices are
connected. The ATM power line will
be wired for a single “duplex”-style
outlet and connected directly to the
AC service panel.
DEDICATED TELEPHONE
3. Ensure the following telephone-
line
requirements are met:
Dedicated line. The telephone line
servicing the ATM will not be a
“party” line or any other shared type
connection.
Proximity to Interference Sources.
The telephone line must not be in
close proximity to “noisy” devices
that could induce interference into the
ATM communications channel.
Current (Max)
• 5.05A @ 120V
• 2.01A @ 240V
Voltage
• 90V - 136V @ 50/60 Hz
• 198V - 257V @ 50/60 Hz
Power Consumption (Idle)
• 2.0A @ 115 VAC at 60 Hz
• 1.0A @ 230 VAC at 50 Hz
Power Consumption (Max Load)
• 606 Watts @ 120V
• 482 Watts @ 240V
RF INTERFERENCE
4. Ensure there are no devices
near the terminal that may
cause RF interference, such as:
TVs
Coolers
Security Devices
Neon Signs
Devices with Compressors
When installing an ATM, some general environmental precautions
need to be considered. Evaluate the location where the ATM will be
installed. To help ensure proper operation of the ATM, ensure the
environmental criteria listed in this checklist are met.