Triton RL5000XP PC-BASED ATMS Installation Manual - Manual (Page 30)

30
RL5000 XP I
NsTaLLaTION
G
UIDE
PARTS SUPPLIED
4 Chemical Anchor
capsules (02316-00002)
4 Threaded chisel-point rods,
M12 x 1.75 (02302-00006)
8 Hex nuts, M12 x 1.75
(02301-00015)
4 Washers (02309-00014)
REQUIRED TOOLS/EQUIPMENT
1 Adjustable Crescent Wrench, or Ratchet Wrench with 18 mm
(3/4-inch) socket
1 Center Punch (for
marking drilling points)
1 Wire Brush (for cleaning
mounting holes)
1 Large Flat Screwdriver 1 Bubble Level
1
Heavy-Duty (Professional-
Grade) Electric Hammer
Drill.
1
6 mm (1/4-inch) and 15 mm
(9/16-inch) Carbide-tipped
Masonry Drill Bits - at least
15 cm (6-inches) long
1 Safety Goggles 1 Ear Plugs or Ear Muffs
(hearing protection)
1 Back-Support Belt 1
Portable Vacuum Cleaner or
Blower (to remove dust and
debris from mounting holes)
1. Carefully inspect the unit for
any shipping damage and report
any damage immediately to
the shipping company. Refer
to the warranty information
in the User or Service manual
(as applicable) for information
about reporting shipping
damage.
2. Remove the unit from the carton
by cutting the straps and removing
the top of the box.
SELECTING THE
INSTALLATION LOCA-
TION
Choosing the right location for
your ATM is very important.
Security concerns suggest a
location that is away from any
door or external access point.
Ideally, the terminal should
be mounted as close to a back
wall as possible. For marketing
reasons, however, it may be
desirable to locate the termi-
nal near the front where your
customers can easily locate it.
Wherever you decide to locate
the terminal, be sure to follow
the recommended procedures
for both mounting the terminal
and for removing cash when
the unit will be unattended.
UL LEVEL 1 CABINET
SAFETY
Level 1 cabinets are consider-
ably heavier than Business
Hours cabinets! Exercise ex-
treme caution when moving
Level 1 cabinets! At least two
persons should work together to
move the cabinet into position
for mounting!
UNPACK CASH DISPENSER
**IMPORTANT**
The RL5000 XP is designed for
indoor installation only!
TOOL USE/SAFETY
Observe ALL safety precau-
tions for operating hand and
power tools! Wear eye and ear
protection while operating the
electric drill! USE A BACK-
SUPPORT BELT WHEN
LIFTING AND MOVING
THE ATM!
**IMPORTANT**
The following procedure applies to
the OPTIONAL Chemical anchor
install kit (06200-00060 - must
purchase)