Triton RL5000XP PC-BASED ATMS Installation Manual - Manual (Page 45)

45
NMD-100 D
IsPENsING
M
ECHaNIsM
R
EMOvaL
/I
NsTaLLaTION
Figure 5. Remove AC power cable.
7. Using two persons, grasp the
green handles and lift the dis-
penser off the rails and slide out
of the cabinet. (Figure 8)
*** WARNING ***
Two persons recommended to re-
move the dispenser from the cabinet.
8. Place the dispenser in a safe
location where it will not get ac-
cidently damaged.
9.* If installing the cabinet at this
time, follow the procedures pro-
vided in “Cabinet Installation”
section of this manual.
Figure 4. Remove shutter and serial
cables (left side of dispenser).
Figure 8. Lift dispenser off rails and
guide out of cabinet. Use 2-person lift!
Figure 6. Remove shutter cable from
clip.
Figure 7. Remove power and data
cable from clips.
Shutter cable
Serial cable
AC power cable
On/Off switch