Triton RL5000XP PC-BASED ATMS Installation Manual - Manual (Page 46)

46
RL5000 XP I
NsTaLLaTION
G
UIDE
R
EINsTaLLING THE
NMD-100
**CAUTION**
Be certain that you have not ap-
plied power to the ATM before you
continue!
1. Refer to Figure 1. Pull the slide
rails out of the cabinet until they
reach their fully extended posi-
tion. The right slide rail has a
locking pin that must be disen-
gaged to extend the rail. Ensure
all cables have been moved out of
the way so they will not be dam-
aged while installing the dispens-
ing mechanism in the cabinet.
2. Pick up the dispensing mecha-
nism by the handles and load it
on to the slide rail by aligning
the tabs (under handle) into the
rail slots. (Figures 1 and 2)
Figure 1. Slide rails extended.
Tab
Rail slot
Figure 2. Tab into rail slot. Use
2-person lift!
**WARNING**
Use only the green handles and
drive motor in rear of dispenser
to lift the mechanism. Two per-
sons recommended to install the
dispenser on to the slide rails.
Figure 3. Route dispenser power and
data cables
Rail slots
3. Refer to Figure 3. Route the
dispensers AC power and serial
data cables as shown in Figure 3
(right side of dispenser).