Triton RL5000XP PC-BASED ATMS Installation Manual - Manual (Page 25)

25
LEVEL FLOORING
REQUIREMENT
It is very important that the
ATM cabinet be located on flat,
level flooring! If the floor is not
flat and level the cabinet bottom
and/or walls may become dis-
torted when the mounting bolts
are tightened down! This could
prevent the security vault door
from closing!
BOLT CABINET TO FLOOR
1. Move the ATM into position for
mounting by aligning the base
over the four holes drilled in the
previous procedure.
2. Place an anchor bolt through the
cabinet base and into one of the
mounting holes. Use a ball peen
hammer to tap the bolt completely
into the hole.
IMPORTANT: If the anchor
bolt “falls” into the hole without
needing to be tapped in, the hole
is too large! The mounting-hole
pattern will have to be moved
and redrilled using smaller holes
as necessary to achieve a snug
fit.
C
abINET
I
NsTaLLaTION
- s
TaNDaRD
a
NCHORs
Place anchor bolts in mounting
holes.
Tap anchor bolts into mounting
holes.
3. Place a flat washer on the anchor
bolt followed by a 1/2” nut.
4. Repeat Steps 2 and 3 for the
remaining anchor bolts.
Sleeve-type anchor bolt