Triton 97XX Series Operation Manual - Manual (Page 52)

TRITON SYSTEMS, INC. 4-17
O
PERATION
M
ANUAL
- M
ODEL
97XX-Series SECTION 4 - CURRENCY HANDLING
2. Move the pusher plate against the notes with just
enough pressure to hold the notes in the correct
position when closing the lid and inserting the
cassette into the mechanism.
3. Close the cassette lid. Fold the lid down to its
locked position. The release button should “pop”
out, allowing the lid to mate cleanly with the body
of the cassette.
Notes lean against packer plate.
Release packer plate.
Close cassette top.
Installing Note Cassettes
Once the cassettes have been loaded with currency,
replace them using the reverse of the steps used to
remove the cassettes from the mechanism. Slide
each Note Cassette into its slot in the mechanism.
Make sure each cassette is fully inserted.
Once all cassettes have been filled and replaced,
they are ready to be LOCKED into position using
the Cassette Lock/Unlock function (see Section 5,
Management Functions, for the appropriate proce-
dure). IMPORTANT: Ensure the MULTIPLE
AMOUNT parameter matches the denomination of
currency in each Note Cassette! See the proce-
dure for using the VALUE function to set this pa-
rameter, in Section 5, Management Functions.
Removing the Reject Vault
The Reject Vault is locked when it is removed from
the dispensing mechanism. The color indicator
shows a green window when the Reject Vault is
opened for note collection (inside the dispensing
mechanism) and when it is ready for use.
The color indicator shows a red window when the
Reject Vault is inserted into the dispensing mecha-
nism and until it is opened for rejected note retrieval.
1. UNLOCK the cassettes, using the Cassette
Lock/Unlock procedure in Section 5, Manage-
ment Functions.
2. Open the outer fascia panel of the security con-
tainer, using the key lock on the front of the panel.
Open the combination lock on the security con-
tainer door and open the door to gain access to
the dispensing mechanism.
IMPORTANT! If you remove the Reject Vault with
power applied, the terminal will sense this and auto-
matically reset the rejected note count to ZERO.
Therefore, to ensure an accurate rejected note count
NEVER REMOVE THE REJECT VAULT WITH
POWER APPLIED WITHOUT CHECKING FOR
AND REMOVING ANY REJECTED NOTES.