Triton 97XX Series Operation Manual - Manual (Page 51)

O
PERATION
M
ANUAL
- M
ODEL
97XX-Series
4-16
SECTION 4 - CURRENCY HANDLING
TRITON SYSTEMS, INC.
• Common notes
Place the prepared bundles in the cassette.
Follow these steps to load notes in the cassette:
1. Level the note pile. Compress the note pile slightly
by hand. Single notes must not protrude from the
bundle. Make sure the bundle leans evenly against
the note plate.
Loading Note Cassettes
Follow these steps to load the cassette with notes.
When loaded, the notes must lean evenly against the
packer plate.
IMPORTANT : The shape of some notes may be
affected by conditions of storage or bundling, prevent-
ing them from forming neat, even piles. If not corrected,
such conditions may cause notes to be rejected by
the dispensing mechanism. To compensate for the
most common conditions of slanting or cupped note
piles, follow the directions given here. Notes with no
apparent shape problems are referred to as “common”
notes.
• Slanting pile
To avoid dispensing problems caused by a “slanting”
pile, put the notes in neat bundles of no more than ½
to ¾ inches in thickness. Turn every other bundle
around to minimize slanting of the pile.
• Cupped bundle
To avoid dispensing problems caused by cupped
bundles, turn all the bundles with the cupped side to-
wards the dispense opening (the “feed” end of the
cassette).
Alternate slanted note piles.
Cupped bundles face dispense opening.
Level the note pile.
Cupped bundles face dispense opening.