LumaSense Technologies 3434i SF6 Leak Detector - Manual (Page 22)

Chapter 2
______________________________________________________________________
_____________________________________________________________________________
BE6028-14 3434i SF6 Leak Detector LumaSense Technologies A/S
Page 22 of 191
the default stored value of the protected IP address press the S3
(DEFAULT) key.
When you have set the protected IP address, press the
¿ key.
If you previously selected that the IP address was NOT to be set
by the DHCP server you will proceed to the below step 11.
If you instead selected that the IP address to be set by the DHCP
server, the screen display now shows the following text.
10. Here the IP address of the 3434i, which has been assigned by the
DHCP server, is displayed. This IP address can be used to
manually set Ethernet communication in a PC application, which
accesses the 3434i gas monitor.
Press the S2 (ACCEPT) key to accept.
11. This concludes the setup of the Ethernet parameters of the 3434i
gas monitor.
Press the SET-UP key to leave the setup.
2.5.2 Display the Homepage of the Monitor
The homepage of the 3434i gas monitor can be displayed if the gas
monitor is connected to a Ethernet network.
In section 2.5.1 it is explained how to set-up the Ethernet
parameters in the 3434i gas monitor.
Any web browser can be used to display the homepage of the gas
monitor. The IP address obtained from the Ethernet set-up of the
3434i gas monitor, can be entered in the address field of the web
browser in order to display the homepage.
The last measured gas values are displayed together with
information about the gas monitor, like the device serial number, if
water- and cross-compensation is performed.
Error and warning messages (see Chapter 14 for further details) will
also be displayed on the homepage.
The grey "Update Measurements" link can be used to update the
homepage with the last measurement results.
CURRENT DHCP ADDRESS 192.168.000.062
ACCEPT