LumaSense Technologies 3434i SF6 Leak Detector - Manual (Page 112)

Chapter 9
______________________________________________________________________
_____________________________________________________________________________
BE6028-14 3434i SF6 Leak Detector LumaSense Technologies A/S
Page 112 of 191
Whenever the Monitor is operating in Memory mode the user can, by
pressing the INFO push-button, find out what percentage of the
Background Memory is occupied and which location numbers have
been used to store data. Fig.9.5 illustrates the status information one
can obtain from the Monitor during various stages of the four
monitoring tasks described above. Further information about the
INFO push-button can be found in section 9.3.4 .
9.3 Management of Data in Background Memory
The monitor has to be operated in Memory mode by pressing the
MEMORY push-button. The following text appears on the screen:
9.3.1 Storing Data in Background Memory
When data is to be copied from Display Memory into Background
Memory:
Press S1
If some data has already been stored in the Background Memory and
you cannot remember which locations have been occupied (used),
press the INFO push-button to find out which locations are occupied
and what percentage of the Background Memory has been used (see
section 9.3.4 ). Use the direction keys to select the desired location
number. When the chosen location number is on the screen, press
S2 to accept the position.
Press Memory to exit.
SELECT MEMORY FUNCTION
STORE RECALL DELETE
LOCATION NUMBER 1
PRESS ENTER TO CHANGE VALUE