Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 9)

Part No. 4801-5072 Rev 9-08 SideWall Curtain Page 9
8.3 Center tracks
1. Refer to Figure 5. Move to the next joint where the edges of two back plates abut, and install
a center track. Align the two topmost holes of the center track with the second holes from the
top of the back plates as shown in Figure 5. Note that the bent vertical edges of the center
track fit underneath the bottom edges of the back plates.
2. Install only one self-drilling lag screw through one hole to loosely hold center track. Note: It
is suggested to install remaining screws after installing all bottom channels (Section 8.6).
3. Install all center tracks by repeating steps 1-2.
8.4 Right track
Refer to Fig. 6. Install a right track at the right end of the Agriculture house. Installation of a
right track is the same procedure as the installation of a left track.
Figure 6
Right track
Left track
Center track
Right track
Figure 5
Center track
Align top holes of center
track with second holes
from top of back plate and
install lag screw into one
screw hole to suspend
center track.
Leave the bottom holes of
center track unfastened to
facilitate installation of
bottom channel.