Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 32)

Part No. 4801-5072 Rev 9-08 Side Wall Curtain Page 32
8.15 Fine Tuning System
After connecting electrical power to system and setting initial limits, exercise the curtains.
1. Open and close the curtains several times to tighten fabric and get rid of wrinkles.
2. Readjust curtain panels as required to achieve satisfactory fit and operation of curtains.
3. After required adjustments, reset limits if necessary.
8.16 Top cover
After completing the curtain installation, and setting and testing the limit switches on the motor,
install the top covers.
1. Refer
to Figure 44. Place top covers as shown.
2. Attach top covers to back plate with self-drilling screws.
8.17 End caps
Refer to Figure 44. Install end caps to each end of the sidewall curtain assembly.
Figure 35
Top covers and end caps
Note: For clarity, drive pipe
not shown in this view.
Top cover
End cap
This completes installation of your side wall curtain assembly.
Figure 44
Top Covers and End Caps