Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 26)

Part No. 4801-5072 Rev 9-08 Side Wall Curtain Page 26
Figure 35 – Manually Close Curtain
Reference to Items in Figure 32 – Adjust Limit Switches
Item Description Item Description
1 Switch HII 11 HI Setting Ring Screw
2 Switch HI 12 Setting Ring
3 Not Used 13 HI Setting Ring Screw
4 Terminal Rail 14 HII Setting Ring
5 Not Used 15 HII Setting Ring Screw
6 Not Used 16 HI Setting Ring
7 Not Used 17 HII Setting Ring Screw
8 Setting Ring 18 SII Setting Ring
9 SI Setting Ring Screw 19 SII Setting Ring
10 HI Setting Ring 20 Not Used
To set the Limit Switches, locate the Lock Motor Control Box.
See Figure 33. NOTE: Items noted in brackets [ ] in this
section can be found in Figure 32.
1. Unscrew the limit Switch Cover and
locate the Allen Wrench and the hex
shaft packaged in the Vinyl Storage Seal.
See Figure 34.
2. Remove the Vinyl Storage Seal and
locate the six Hex Adjusting Screws on
the Ring Screws. See Figure 35.
3. Run the curtains to the bottom position by using a Crank or
Drill [Item 14 Figure 31] or by manually turning the one of the
three Left Adjusting Screws with the Allen Wrench from the
Vinyl Seal as illustrated in Figure 35. NOTE: If turning the
drive with drill and adaptor, run to end position carefully (very
slowly). Maximum drive speed is 1400 rpm.
Limit Switch
Cover removed
Allen wrench
for adjusting
Limit Switches
Hex shaft for
manually
rotating motor
Vinyl
Storage
Seal
Figure 34 – Remove Limit Switch Cover
Lock Motor
Figure 33 – Lock Motor
Limit Switch
Cover
Curtain Moves Down