Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 12)

Part No. 4801-5072 Rev 9-08 SideWall Curtain Page 12
8.7 Top bar
Refer to Fig. 9. Align the holes of the top bars with the holes in the track and attach with nuts and
screws. The hook & loop side faces upward. Repeat for all units.
8.8 Drive Pipe Assembly
The drive pipe is composed of sections that connect together with pop rivets.
IMPORTANT! SPECIAL INSTRUCTIONS FOR SOMFY MOTOR:
The pipe segment having a 7.5 mm x 35 mm notch attaches to the tubular motor and should be
located at the end where the motor is to be installed. This will determine how the pipe sections are
arranged for interconnection.
1. Starting at one end of the sidewall opening, arrange the drive pipe sections on the ground end-
to-end with the swedge ends nonadjacent. If installing a Somfy motor, place the slotted
section of pipe at the end of the assembly where the motor will be installed.
7.5mm x 35mm (Somfy only)
Keep hook & loops strips aligned when assembling drive pipe. Swedged end
Note: Install top bar by
attaching to holes in track
units as shown. Attach
with bolts and nuts to each
end of top bar.
Top bar
FIGURE 9
Top bar
Note that the hook & loop
strips point upward.